The situation
A Turkish manufacturer of compressed air dryers and oil-water separators was fielding complaints about carryover. Its separators used a pleated media cartridge, and once the cartridge loaded with oil mist the pressure drop climbed quickly, forcing early element changes and eating into the service interval promised to end users.
The company wanted a coalescing layer that would hold oil mist without blinding, could be washed and reused, and would not corrode in condensate that carried acidic traces.
Solution selected
We supplied stainless steel 304 knitted filter wire mesh in 66 mm width as the coalescing and demisting layer, combined with a knitted mesh drainage path so separated oil could run down to the bowl instead of re-entraining in the air stream.
| Parameter | Value |
|---|---|
| Material | Stainless steel 304 knitted wire mesh |
| Filter rating | 99 % oil and mist removal in application tests |
| Mesh width | 66 mm, custom widths available |
| Hole size | 2 × 3 mm nominal |
| Corrosion resistance | Suitable for condensate with acidic traces |
| Reusability | Washable, reusable after cleaning |
| Certification | ISO 9001:2015 |
| Supply ability | Up to 999 kg per 5 days |
Implementation steps
- Application review. We asked for the operating pressure, inlet oil concentration and target outlet concentration before recommending a mesh density — the same mesh that works at 7 bar will underperform at 16 bar.
- Prototype build. Free samples were supplied so the customer could build ten prototype separator elements and run them on its in-house test bench.
- Bench validation. The customer measured outlet oil concentration and pressure drop across a full loading cycle, comparing the knitted mesh against the previous pleated cartridge.
- Production and repeat orders. After validation the mesh was released as the standard coalescing layer across three separator sizes.
Measured improvement
- Oil carryover fell to within the 99 % removal target the customer had promised to its end users.
- Pressure drop stayed flat for a much longer period, extending the service interval between element changes.
- Because the mesh can be cleaned and reused, the customer's maintenance customers reduced consumable spend.
- Corrosion complaints from coastal installations stopped after the switch to SS304.
Why it worked
The improvement came from structure, not from a finer pore size. A knitted mesh gives a tortuous path that lets droplets collide, grow and drain, while a pleated media traps them and blinds. Once the customer understood that difference, the specification changed permanently.
For separator OEMs facing the same problem, request samples of two or three mesh densities and test at the real operating pressure. The right density is the one that gives you the target outlet concentration with the lowest pressure drop penalty — not simply the finest mesh available.
![]()



