Anping Zhaotong Metal Netting Co., Ltd has extended its knitted wire mesh range for automotive exhaust applications, with 35 mm width formats in copper and stainless steel 304 now offered as standard for muffler packing, thermal barrier layers and catalytic converter support.
The change responds to how Tier-1 exhaust suppliers actually buy mesh: not by square metre, but by coil matched to the feed width of a specific wrapping station.
| Item | Requirement |
|---|---|
| Material | Copper and stainless steel 304, supplied separately |
| Mesh width | 35 mm standard, tolerance ±0.5 mm |
| Wire diameter | Selected per muffler variant |
| Surface | Clean, oil-free, no loose filament ends |
| Form | Continuous roll on cardboard cores |
| Certification | ISO 9001:2015 |
| Capacity | Up to 999 pieces per day |
| Delivery | About 7–10 days after payment |
Automotive mesh projects qualify or fail on width tolerance and end condition. A width variance above half a millimetre causes jamming in automated wrapping, and a loose filament end can migrate downstream and damage a component far more expensive than the mesh itself.
Knitted mesh serves three purposes in an exhaust system: it supports the acoustic packing so it does not migrate under pulsation, it acts as a thermal barrier between the hot core and the shell, and it absorbs structure-borne vibration from the engine. Copper is chosen where thermal conductivity and damping matter most; SS304 is chosen where cost and corrosion resistance dominate.
Coils are wound on cardboard cores, wrapped in waterproof paper with a plastic outer layer, and packed in wooden cases sized to the customer's stillage. Roll lengths are quoted per variant so the wrapping station receives a coil that matches its magazine depth, and the coil label carries the measured width for incoming inspection. Cut lengths and pre-slit narrow formats are available for lines that cannot slit in-house.
![]()
Contact Person: Mrs. Aimee
Tel: +86 13103181658
Fax: 86-0318-7528518